Reasons for poor sealing of magnesium reinforced porcelain disinfection tableware packaging

In order to prevent contamination after the disinfection of the tableware, the manufacturer will pack it immediately after the inspection, otherwise it will be polluted by dust particles in the air, caused by magnesium reinforced porcelain disinfection tableware unsanitary, but there will be a situation that the sealing is not good also caused by pollution, then what is the reason for the sealing is not good? 1. In general, the sealing mouth of magnesium reinforced porcelain disinfection tableware is not tightly sealed. It may not be sealed because the temperature of the packaging machine is not high enough. The power of the hand-pressed sealing machine is 180 W- 400 W, because the power is not enough and the temperature cannot reach the required high temperature, generally speaking, thick plastic bags or aluminum bags need continuous or pedal sealing packaging machines. 2. If the sealing equipment for disinfecting tableware can be sealed, and the near sealing is not firm, it may be that the control panel or knob of the hand-pressed sealing mouth does not seal the sealing machine is broken, therefore, press down slightly when sealing. 3. If the lacquer cloth is burnt out, it may also cause lax sealing. The solution is to replace it with a new lacquer cloth. While doing a good job of disinfection, manufacturers should regularly check whether the packaging machine for magnesium reinforced porcelain disinfection tableware is qualified, including the already packaged tableware, to see if there is any loose packaging, for the packaging film, it is recommended to use a thicker one, which can ensure that it is not easily damaged after packaging. Small editor: fir