how to wash dishes by hand in a restaurant how to install a kitchen sink -

The kitchen sink is one of the most important things in the kitchen.You need it to prepare and process food, wash dishes, etc.Installing the kitchen sink can look hard and complicated and many of you may want to hire professionals to do it, but in fact you can do it yourself and save a lot of money.You just need some simple instructions.1.Properly locate the openingMost sink with the template provided by the sink manufacturer to help you accurately mark the profile of the hole and ensure the correct location.Place the template on the countertop.Make sure it's exactly where you want it and have to place it so it's at least 1.5 to 2 inch from the edge of the countertop.Paste the template with tape and draw a line directly around the edge on the counter with a marker.After completing this step, delete the template.2.Cutting drill 3/8Mark the inches diameter holes in each corner of the opening.Use jigsaw puzzles or military knives-The saw blade is cut along the marked workpiece.Remove the cut-Go out after you finish the cutting procedure.3.Install the kitchen faucet and sink filter first install the kitchen faucet or faucet sprayer before installing the kitchen sink.After that, install the sink filter.4.Install the kitchen sinkFlip sink to fall over.If you don't want the countertop scratched, you can put some scrap sticks on the edge of the opening.It also protects your fingers.The sink is usually fixed with special mounting clips tightened by a screwdriver.The spacing of the clips may vary.Please refer to the manufacturer's manual.5.The last step is to connect the sink to the parts under the sink.Connect P-first-Trap.The faucet line is then connected to the hot and cold supply line using a flexible supply pipe.Connect the filter to the drain.After ensuring that all devices are securely connected, turn on the water flushing system.Let it run for a few minutes and then reinstall the oxygen generator.Your new sink is good!